Exclusive distributor in AU
Gel-Revitalizant for Cylinders
Availability: In Stock
Product contains Revitalizant Best seller

Gel-Revitalizant for Cylinders

Gel-Revitalizant for Cylinder is designed for restoring repair and wear protection of the engine cylinder-piston group without disassembling. 

Gel-Revitalixant forms cermet coating on friction surfaces of the engine cylinder-piston group. 

After XADO revitalization the cylinder geometry restores, the inner diameter reduces, ellipse deformation of cylinders disappears preventing expensive overhaul.

Choose product to view its image on the left
Gel-Revitalizant for Cylinders
Pack: Price:
$35.00
Prices without delivery

General characteristics of the cermet layer:

  • Microhardness – 750 kg/mm2; 
  • High corrosion resistance;
  • Roughness Ra up to 0,06 mkm.

Application: 

Step 1: Warm up the engine (the engine should be warm, but not hot).

Step 2: Remove the spark-plug from the cylinder and disconnect the central wire of ignition distributor and igniter.

Step 3: For two-stroke engines fix the piston in the upper “dead” spot (in order to avoid getting the gel into the inlet and outlet windows).

Step 4: Squeeze out the tube content into the cylinder. 

Note! Squeeze the content into the cylinder wall and not on the piston!!! 

Step 5: Perform 15-20 piston strokes (by hand crank, towing, turning of a driving wheel etc.).

Step 6: Screw in the spark-plug and start the starter 3-4 times for 3-4 sec with the time break of 15-20 sec.

Step 7: For two-stroke engines the content of one more tube should be dissolved in 5 – 10 mi of motor oil and added into the fuel tank.

Step 8: Connect the central transmission, igniter; start the engine and operate at idle run for 15 min.

Step 9: Operate in a normal mode.

Dosage:

1 cylinder – 1 tube.

Note:

  • Use medical syringe with a plastic tube in hard-to-reach places. In this case the gel should be dissolved in 5 – 10 ml of motor oil. In order to avoid hydroblow the total volume of the fluid added into cylinder must not exceed 20 ml!
  • At diagnostics always check the adjustment and accuracy of the valve mechanism!
  • Increases compression;
  • Removes holes and scratches up to 0,0003 inch ;
  • Protects cylinders from wear-out during “cold” start;
  • Reduces noise and vibration level;
  • Increases engine power;
  • Reduces fuel consumption;
  • Allows to process one or couple cylinders.
  Bad            Good
captcha ->